The tubular aluminum busbar is composed of three-phase four-wire and five-wire, suitable for industrial and mining areas, and even suitable for equipment renovation near high-rise buildings or workshop equipment renovation. Dense tubular busbars.
But how are Tubular Aluminium Busbars equipped? In fact, its equipment is not as difficult as one might think. It is evenly divided into three processes and careful planning is sufficient. Equipment for dense tubular busbars: For the connection of busbars, please use high-strength insulating plates with high insulation, arc resistance and flame retardancy as connection accessories, and fasten them with bolts with insulating sleeves.
According to the requirements of the standard, in order to meet the overlapping area of the busbar, the gap between the bolt holes and the bolts is small, because the Tubular Aluminium Busbars increase the insulating sleeve, so that the gap is narrowed; therefore, when connecting the two-section tubular busbar main When connecting the busbars, the axes of the two busbars should be strictly kept on the same center line, and the busbars of the two tubular busbars and the bolt holes of the insulating plate should be completely consistent. Align. When tightening the bolts, each bolt must be applied evenly in sequence.
This is to prevent damage to the insulating sleeves on the bolts due to shear forces during installation. In the process of engineering construction, several reasons have been found for the falling state of the Tubular Aluminium Busbars insulation caused by the damage of the bolt insulation sleeve. The ground connection can be met by using busbar shells, but when painting all busbar shells, the two parts of the tubular busbar must be connected to the wire by grounding bolts.
